Be surprised by the effectiveness of the homemade pipe unblocker

parvensorkar14

In your daily life you use, surely without realizing it, a multitude of polluting and dangerous chemicals for your health. As Ecologistas en Acción details ,  household cleaning products can be composed of toxins, including those used to unclog pipes that contain chlorine and sulfuric acid, both toxic and corrosive. Download our free guide on responsible consumption here, full of tips to adopt healthy and sustainable habits. Homemade, natural and effective unblocker No matter how much care you take, inevitably, at some point, you will have a blockage in the pipes. What can you do if you want to avoid chemical plungers? Make your own homemade, natural and effective plunger! We share several ideas from Koysa . Aim! Vinegar, baking soda and water This method is the most traditional and is still used due to its simplicity and effectiveness.

Vinegar contains acetic acid, which has a bactericidal effect that makes it an effective ecological cleaner. Baking soda, thanks to its absorbent capacity, helps vinegar in the work of removing dirt. You must follow these steps: First remove any retained water from the basin or sink. Pour half a cup of baking soda down the drain and let it sit for a few moments. Pour Panama Phone Number List half a liter of boiling water. You will see that an effervescence occurs that will help remove dirt from the pipe. Let it sit for 10 minutes or until all the water has drained away. Next, add half a cup of baking soda again. After a few moments, pour a glass of vinegar on top. Greater effervescence will occur than with water. Let the mixture act for about 10 minutes. Finally, pour two liters of boiling water on top. You can repeat the operation two or three times, if necessary.



Soap powder Another simple homemade unblocker (if the clog is small) consists of pouring a large amount of powdered soap down the drain and, after that, a pot of boiling water. This recipe has a variant: instead of powdered soap you can add salt to the water, which also eliminates the bad smell of the pipes. Wire In hardware stores you can find several models of manual plungers to insert into the pipes and drag the dirt out. But you can also make your homemade plunger with an old wire hanger. You just have to undo the hanger, stretch the wire and shape it into a 'U' at one end . Then, you insert it carefully and move it, putting it in and taking it out until no more residue comes out. "cheese dumper" Dismantle the siphon If neither of these two methods has worked for you, your traffic jam is big. But don't give up, you don't need to call the plumber if you're a bit handy. You can dismantle the siphon (don't forget to first place a basin under it to collect the retained water) and clean it with boiling water. Before reassembling it you can use the 'U' shaped wire to reach the non-removable areas the pipe inside the wall.